Virtual Console FCD-CFxx Información técnica descargar pdf (Pagina 810)

100

101

• <physical disk name> = "Physical Disk 1:0:5 on Controller 0 at Connector 1"

4.3.8.81 PDR213 : "The state of <physical disk name> changed from Non-RAID to Ready."

When event is generated, message will have the following substitutions:

• <physical disk name> = "Physical Disk 1:0:5 on Controller 0 at Connector 1"

4.3.8.82 PDR214 : "The <physical disk name> is not supported because it is not supplied by

an authroized hardware provider."

When event is generated, message will have the following substitutions:

• <physical disk name> = "Physical Disk 1:0:5 on Controller 0 at Connector 1"

4.3.8.83 PDR215 : "Copyback task to <physical disk name> has failed."

When event is generated, message will have the following substitutions:

• <physical disk name> = "Physical Disk 1:0:5 on Controller 0 at Connector 1"

4.3.8.84 PDR9000 : "Foreign Configuration was detected on <physical disk>."

When event is generated, message will have the following substitutions:

• <physical disk> = "Disk 5 in Enclosure 0 on Connector 0 of RAID Controller in Slot 5"

4.3.9 Subcategory= Power Supply [MessageID prefix =PSU]

4.3.9.1 PSU1000 : "Power supply cable has been removed from <PSU Sensor Name>."

When event is generated, message will have the following substitutions:

• <PSU Sensor Name> = "PSU 1 in Enclosure 0 on Connector 0 of RAID Controller in Slot 5"

4.3.9.2 PSU1001 : "<PSU Sensor Name> has failed."

When event is generated, message will have the following substitutions:

• <PSU Sensor Name> = "PSU 1 in Enclosure 0 on Connector 0 of RAID Controller in Slot 5"

4.3.9.3 PSU1002 : "<PSU Sensor Name> was removed"

When event is generated, message will have the following substitutions:

• <PSU Sensor Name> = "PSU 1 in Enclosure 0 on Connector 0 of RAID Controller in Slot 5"

4.3.9.4 PSU1003 : "<PSU Sensor Name> is switched OFF."

When event is generated, message will have the following substitutions:

• <PSU Sensor Name> = "PSU 1 in Enclosure 0 on Connector 0 of RAID Controller in Slot 5"

4.3.9.5 PSU1004 : "Power supply cable has been inserted into <PSU Sensor Name>."

When event is generated, message will have the following substitutions:

• <PSU Sensor Name> = "PSU 1 in Enclosure 0 on Connector 0 of RAID Controller in Slot 5"

810

1 2 ... 805 806 807 808 809 810 811 812 813 814 815 ... 919 920

Virtual Console FCD-CFxx Información técnica Pagina 810

Comentarios a estos manuales