4.3.12.31 STOR0506 : "Unable to create virtual disk."
4.3.12.32 STOR0507 : "Insufficient physical disk space on selected RAID controller."
4.3.12.33 STOR0508 : "No supported controllers present for RAID configuration."
4.3.12.34 STOR0509 : "No RAID levels are supported."
4.3.12.35 STOR0510 : "Encryption configuration failed."
4.3.12.36 STOR0511 : "Unable to change the encryption key."
4.3.12.37 STOR0512 : "Unable to apply the encryption key."
4.3.12.38 STOR0513 : "Unable to encrypt virtual disks."
4.3.12.39 STOR0514 : "Unable to initialize the selected physical disk drive(s)."
4.3.13 Subcategory= Software Change [MessageID prefix =SWU]
4.3.13.1 SWU001 : "The backplane firmware update completed successfully."
4.3.13.2 SWU002 : "The backplane firmware update did not complete successfully."
4.3.14 Subcategory= Temperature [MessageID prefix =TMP]
4.3.14.1 TMP7 : "<Temp Sensor Name> has failed."
When event is generated, message will have the following substitutions:
• <Temp Sensor Name> = "Temperature Sensor 0 in Enclosure 0 on Connector 0 of RAID Controller in
Slot 5"
4.3.14.2 TMP1000 : "<tempsensor name> exceeded the maximum warning threshold."
When event is generated, message will have the following substitutions:
• <tempsensor name> = "Temperature Sensor 0 in Enclosure 0 on Connector 0 of RAID Controller in
Slot 5"
4.3.14.3 TMP1001 : "<tempsensor name> has crossed the minimum warning threshold."
When event is generated, message will have the following substitutions:
• <tempsensor name> = "Temperature Sensor 0 in Enclosure 0 on Connector 0 of RAID Controller in
Slot 5"
4.3.14.4 TMP1002 : "<tempsensor name> has exceeded the maximum failure threshold."
When event is generated, message will have the following substitutions:
• <tempsensor name> = "Temperature Sensor 0 in Enclosure 0 on Connector 0 of RAID Controller in
Slot 5"
815
Comentarios a estos manuales